Chan.control - Revision history

Andrei at 15:33, 8 February 2013

2013-02-08T15:33:50Z

Andrei at 15:32, 8 February 2013

2013-02-08T15:32:11Z

Dana at 10:29, 21 January 2013

2013-01-21T10:29:07Z

Dana at 10:28, 21 January 2013

2013-01-21T10:28:56Z

Dana at 14:35, 19 October 2012

2012-10-19T14:35:09Z

Dana: Created page with " This message is used to apply various operations and parameter changes to existing channels or components. ===Parameters=== ;targetid :id of the channel to control ;compone..."

2012-10-19T14:33:19Z

Created page with " This message is used to apply various operations and parameter changes to existing channels or components. ===Parameters=== ;targetid :id of the channel to control ;compone..."

New page

This message is used to apply various operations and parameter changes to existing channels or components.

===Parameters===

;targetid
:id of the channel to control
;component
:name of the signaling component to control

===Optional parameters===

Each channel and component supports various optional parameters depending on its type.
;operation
:operation to perform on the component
;out_volume
:playback volume to set in client channels
;in_volume
:recording volume to set in client channels

'''Note'''
*This message is generated by the [[rmanager]] [[Rmanager Commands|command control]], in that case '''targetid''' and '''component''' are set to the same value.
*SS7 components can be controlled at runtime by [[ysigchan#commands_isup|specific commands]].
*The client also uses this message for volume control.

@@ Line 25: / Line 25: @@
 *If the message is generated from rmanager, chan.control will succeed if the requested component is found, even if the requested operation failed to be executed.
-rmanager control return status messages:
+;rmanager control return status messages:
      - Could not control COMMAND; If the target component is not found
      - Control 'COMPONENT_NAME' FAILED; if the component with COMPONENT_NAME is found but failed to execute the requested operation.
      - Control 'COMPONENT_NAME' OK; if the component with COMPONENT_NAME is found and the requested operation succeeded.
-This behavior is available since revision 5396.
+;This behavior is available since revision 5396.

@@ Line 23: / Line 23: @@
 *SS7 components can be controlled at runtime by [[Signaling_module#SS7_ISUP_commands|specific commands]].
 *The client also uses this message for volume control.
 '''See also'''
 *[[chan.replaced]]

← Older revision		Revision as of 10:28, 21 January 2013
Line 23:		Line 23:
	*SS7 components can be controlled at runtime by [[Signaling_module#SS7_ISUP_commands\|specific commands]].		*SS7 components can be controlled at runtime by [[Signaling_module#SS7_ISUP_commands\|specific commands]].
	*The client also uses this message for volume control.		*The client also uses this message for volume control.
		+
		+	'''See also'''
		+
		+	*[[chan.replaced]]

@@ Line 20: / Line 20: @@
 '''Note'''
-*This message is generated by the [[rmanager]] [[Rmanager Commands|command control]], in that case '''targetid''' and '''component''' are set to the same value.
+*This message can be generated by the [[rmanager]] [[Rmanager Commands|command control]], in that case '''targetid''' and '''component''' are set to the same value.
 *SS7 components can be controlled at runtime by [[Signaling_module#SS7_ISUP_commands|specific commands]].
 *The client also uses this message for volume control.