Liviu: /* Notes */

2017-10-26T14:09:07Z

‎Notes

Liviu at 12:18, 26 October 2017

2017-10-26T12:18:22Z

Monica at 10:26, 4 November 2013

2013-11-04T10:26:01Z

Monica: Replaced content with " This is a support module providing a standard factory for the common lower layer of SIGTRAN protocols. '''See also''' * Modules"

2013-07-10T13:01:39Z

Replaced content with " This is a support module providing a standard factory for the common lower layer of SIGTRAN protocols. '''See also''' * Modules"

Can't load revision 6255

at 14:54, 10 June 2013

2013-06-10T14:54:55Z

Can't load revision 6162

at 14:54, 10 June 2013

2013-06-10T14:54:37Z

Can't load revision 6161

at 15:06, 13 November 2012

2012-11-13T15:06:14Z

Can't load revision 1944

at 10:17, 9 October 2012

2012-10-09T10:17:33Z

Can't load revision 505

at 10:17, 9 October 2012

2012-10-09T10:17:07Z

Can't load revision 504

at 10:11, 9 October 2012

2012-10-09T10:11:36Z

Can't load revision 502

← Older revision		Revision as of 14:09, 26 October 2017
Line 131:		Line 131:

	All other transport protocols are not standard but usually available.		All other transport protocols are not standard but usually available.
−
−
−	~~'''See also'''~~
−
−	* [[Modules]]

← Older revision		Revision as of 12:18, 26 October 2017
Line 1:		Line 1:
		+	This is a support module providing a standard factory for the common lower layer of SIGTRAN protocols. Here is where the IP addresses, ports and protocols are configured.
		+
		+	Each connection defined by this module is referenced from [[Ysigchan\|ysigchan]] or some other module.
		+
		+	===Configuration===
		+
		+	sigtransport.conf
		+
		+	; Each section in this file describes a SIGTRAN connection
		+	; Connections are referenced from other configurations describing the upper layer
		+
		+	;[name-of-connection]
		+	; The name of the section identifies the connection
		+
		+	; type: keyword: Socket type - sctp, tcp, udp, unix
		+	;type=sctp
		+
		+	; stream: bool: Socket connection type.
		+	; Designed for SCTP sockets to create a stream socket or a sequenced packet socket
		+	; NOTE: for M2PA if stream is false the M2PA autostart should be on true on both ends,
		+	; if stream is true the M2PA autostart must be true only at one end
		+	;stream=true for TCP or UNIX sockets, false for other types
		+
		+	; local: string: Primary local address
		+	; Format is ipv4:port like: 1.1.1.1:3566
		+	;local=
		+
		+	; localN: string: Additional local addresses, SCTP only
		+	; Multiple addresses can be specified by incrementing the 1-based index at the end of 'local'
		+	; The address format is ip:port like:
		+	; local1=1.2.3.4:3566
		+	; local2=2.3.4.5:3566
		+	;local1=
		+
		+	; remote: string: Primary remote address
		+	; Format is ipv4:port like: 2.2.2.2:3566
		+	;remote=
		+
		+	; remoteN: string: Additional remote addresses, SCTP only
		+	; Multiple addresses can be specified by incrementing the 1-based index at the end of 'remote'
		+	; The address format is ip:port like:
		+	; remote1=5.6.7.8:3566
		+	; remote2=6.7.8.9:3566
		+	;remote1=
		+
		+	; endpoint: bool: Set to true if this is an endpoint that actively tries to connect,
		+	; false to listen for remote connections
		+	;endpoint=false
		+
		+	; linger: int; How much to block waiting for socket to close.
		+	;linger = 0
		+
		+
		+	; SCTP parameters
		+	; NOTE these parameters will be set only for SCTP sockets
		+	; Note! On some platforms this parameters may not be supported
		+
		+	; Set initial retransmission interval in milliseconds
		+	; Ex: rto_initial = 400
		+	;rto_initial=
		+
		+	; Set maximum retransmission interval in milliseconds
		+	; Ex: rto_max = 800
		+	;rto_max=
		+
		+	; Set minimum retransmission interval in milliseconds
		+	; Ex: rto_min = 200
		+	;rto_min=
		+
		+	; Set heartbeat interval in milliseconds
		+	; Ex: hb_interval = 5000
		+	;hb_interval=
		+
		+	; Set maximum number of retransmissions before the SCTP connection is considered down
		+	; Ex: max_retrans = 5
		+	;max_retrans=
		+
		+	; Enable / disable SCTP heartbeat. Default is enabled
		+	; Ex: hb_enabled = true
		+	;hb_enabled=
		+
		+	; Set sctp delayed ack parameters
		+	; Note! Both sack_delay and sack_freq must be present and have values different than 0 to be successfully applied
		+
		+	; Set ack time interval for sccp to cumulative acknowledge the received packets
		+	; Max value 500 in milliseconds
		+	; Ex: sack_delay = 50
		+	;sack_delay=
		+
		+	; Set the maximum number of unacknowledged packets
		+	; Ex: sack_freq = 2
		+	; Note! If you set this to 1 you will disable the sctp acknowledge algorithm
		+	;sack_freq=
		+
		+	=== Example===
		+
		+	This is a working example for a SCTP based M2PA link and linkset that sends the packets back.
		+
		+	'''sigtransport.conf''':
		+
		+	[localhost]
		+	type=sctp
		+	local=127.0.0.1:3000
		+	remote=127.0.0.1:3000
		+	endpoint=yes
		+
		+	'''ysigchan.conf''':
		+
		+	[local-linkset]
		+	type=ss7-mtp3
		+	netind2pctype=ITU
		+	local=ITU,0-0-3
		+	adjacent=ITU,0-0-1
		+	adjacent=ITU,0-0-2
		+	link=local-link
		+
		+	[local-link]
		+	type=ss7-m2pa
		+	sig=localhost
		+	autostart=yes
		+
		+	=== Rmanager commands ===
		+
		+	This modules is controlled indirectly by [[Ysigchan#Status_and_control_commands\|ysigchan]] using commands addressing the SIGTRAN component.
		+
		+	===Notes===
		+
		+	The SIGTRAN standards only support the [http://en.wikipedia.org/wiki/Stream_Control_Transmission_Protocol SCTP] protocol which is not always available in the operating system.
		+
		+	In Yate the SCTP sockets are optional and are provided by a module like [[lkSCTP]].
		+
		+	All other transport protocols are not standard but usually available.
		+
		+
		+	'''See also'''
		+
		+	* [[Modules]]

−	~~This is a support module providing a standard factory for the common lower layer of SIGTRAN protocols.~~

	'''See also'''		'''See also'''

← Older revision		Revision as of 10:26, 4 November 2013
Line 5:		Line 5:

	* [[Modules]]		* [[Modules]]
		+
		+	[[Category:SS7]]

SigTransport - Revision history

Liviu: /* Notes */

Liviu at 12:18, 26 October 2017

Monica at 10:26, 4 November 2013

Monica: Replaced content with " This is a support module providing a standard factory for the common lower layer of SIGTRAN protocols. '''See also''' * Modules"

at 14:54, 10 June 2013

at 14:54, 10 June 2013

at 15:06, 13 November 2012

at 10:17, 9 October 2012

at 10:17, 9 October 2012

at 10:11, 9 October 2012