Debugging and, or Investigation of messages
The module msgsniff is for you to probe all the messages being generated and, or received by Yate and, or the modules compiled and enabled in yate.conf file.
This is a module you will use rather rarely, obviously it should be off by default.
The loading of msgsniff.yate is controlled by yate.conf like any other module.
The initial activation is controlled by msgsniff in [general] of same yate.conf file. The default status is off as it would flood the logs and hit the performance.
Enable msgsniff in configuration
The sniffer will dump the Yate messages to output or log depending:
- It can be enabled in yate.conf:
[general] msgsniff=yes
After enable the sniffer, start Yate with logging:
./run -vvvvv -l yate.log
If there is no message in the console when you are making a call then the sniffer module is not loaded. Check if msgsniff.yate module is present in modules directory.
Enable / Disable sniffer in telnet
telnet 0 5038 sniffer on
and disabled with:
sniffer off
Example
- Enable msgsniff module from Yate's main configuration file:
yate.conf
[general] modload=no [modules] ;for debugging yate rmanager.yate=yes msgsniff.yate=yes
- The sniffer can be turned on and off from rmanager using the commands:
sniffer on sniffer off
- Apply filter by specifying regex to match:
sniffer filter ^\(chan\.\|engine\.halt$\)
See also
