SCCP decoder
From Yate Documentation
(Difference between revisions)
| Line 17: | Line 17: | ||
See also: | See also: | ||
*[[SCCP Introduction]] | *[[SCCP Introduction]] | ||
| − | *[[SCCP_address_translation | SCCP Address Translation] | + | *[[SCCP_address_translation | SCCP Address Translation]] |
*[[STP SCCP configuration]] | *[[STP SCCP configuration]] | ||
*[[SEP SCCP configuration]] | *[[SEP SCCP configuration]] | ||
*[[Configure SCCP and GTT]] | *[[Configure SCCP and GTT]] | ||
Revision as of 17:04, 26 October 2017
This is a special non-standard feature of YATE.
The SCCP can be used as a SCCP message decoder. This case can be found if SCCP is used with M3UA-GW.
YATE M3UA-GW has the ability to route messages to ASPs based on SCCP GT or/and SSN, in this way the SCCP is used to decode the SCCP message for M3UA-GW so that the gateway can look for the routing parameters.
To activate this feature set in ysigchan.conf
[sccp] type=ss7-sccp pointcodetype=ITU localpointcode=7 priority=0 decoder=true
See also:
