VoIP PSTN Gateway
(→Routing in Yate) |
(→Circuits) |
||
| Line 32: | Line 32: | ||
The callednumber is, obvious, the called party's number. The '''trunk''' parameter is mandatory and indicates the trunk to use to make the call. '''trunkname''' must be the name of an active trunk configured in [[Signaling module|ysigchan.conf]]. | The callednumber is, obvious, the called party's number. The '''trunk''' parameter is mandatory and indicates the trunk to use to make the call. '''trunkname''' must be the name of an active trunk configured in [[Signaling module|ysigchan.conf]]. | ||
| − | == | + | == Parameters == |
| − | For incoming calls in ISDN the circuit it can be modified, but for ISUP the circuit it cannot be modified. | + | There are some common parameters for both protocols like called number, caller number. |
| + | |||
| + | The ''circuit'' parameter has different behavior. For incoming calls in ISDN the circuit it can be modified, but for ISUP the circuit it cannot be modified. | ||
| + | |||
| + | For more information see the parameters described in [[Signaling module|ysigchan.conf]] file. | ||
Revision as of 09:18, 2 April 2013
Yate has the functionality of a Voip - PSTN gateway.
It's main task is to provide signailing interworking and to transform the information it receives on one side in information compatible with the other side, like SIP to ISDN and / or SIP to SS7.
Contents |
VoIP <-> PSTN Gateway in Yate
Yate can connect the existing PBX to alternative VoIP providers providing cost savings for enterprises.
It can also be used by providers to connect their TDM network to IP networks providing cost savings for long distance calls.
For this application usage of Sangoma cards is necessary.
Configuration in Yate
To configure SIP to ISDN and / or SIP to SS7 (ISUP) you will need:
- signalling
- voice circuits that can be:
- - local: Sangoma or Zaptel cards. This can be configurate in Yate in files: wpcard.conf and zapcard.conf.
- - remote: MGCP (to control a media gateway)
For configuring Yate for SIP to ISDN or SS7 (ISUP) you need to configure ysigchan.conf file:
- an ISUP trunk is a container for an ISUP call controller
- an ISDN trunk is a container with a Q.931 call controller, a circuit group (voice circuits), a Q.921 data link and an HDLC signalling interface.
Routing in Yate
The routing it is done from regexroute.conf in the same way for ISDN and/or ISUP by addressing the trunk configured in ysigchan.conf.
Syntax: sig/callednumber;trunk=trunkname
The callednumber is, obvious, the called party's number. The trunk parameter is mandatory and indicates the trunk to use to make the call. trunkname must be the name of an active trunk configured in ysigchan.conf.
Parameters
There are some common parameters for both protocols like called number, caller number.
The circuit parameter has different behavior. For incoming calls in ISDN the circuit it can be modified, but for ISUP the circuit it cannot be modified.
For more information see the parameters described in ysigchan.conf file.
See also
