Cpuload

File cpuload.conf

NOTE this file is used to setup CPU load information's

The cpuload module inform YATE about system total CPU load and YATE CPU load

[general]

This section keeps the settings for system and Yate.

interval

int: The interval in milliseconds for CPU load check.

Note

Minimum value is 1s.

Default value 1s

interval=1000

oscillate_interval 

int: Time in milliseconds that stop this module from notifying about CPU load,

if the CPU load is oscillating between consecutive intervals

NOTE! oscillate_interval value should be at least 2 * interval

oscillate_interval=5000

core_number

integer: The number of CPU cores

NOTE! Yate will detect the number of cores from "/proc/stat". If the file does not exists you should

set the core number to avoid that yate CPU load to be bigger than 100%

core_number=1

smooth 

integer between 5 and 50 : Value used to smooth the CPU loading.

smooth = 33

The following sections represent the CPU load managers.

NOTE!!! Each parameter form the following sections need to match this type

target_name=interval_name,threshold_value,hysteresis_value;......

target_name

string: The name if the target.

interval_name 

string: The name of the interval.

threshold_value

int: The upper value of the interval.

hysteresis_value

int.

Examples

engine=accept,50,4;partial,65,2;congestion,80,2;reject

The target is "engine";

Interval names

all, partial,congestion,none;

Threshold value

50, 65, 80

from this results two sets of intervals

one when the CPU load is growing 

accept = 0-54

partial = 54 - 67

congestion = 67 - 82

reject = 82 - 100

two when CPU load is lowering

accept = 0-46

partial = 46 - 63

congestion = 63 - 78

reject = 78 - 100

NOTE! 

Parameters can be appended with chan.control message and with rmanager command

Example

rmanager

"control cpuload section target_name=interval_name,threshold_value,hysteresis_value;......"

where "section" represents one from the sections above

Example: chan.control

Message* m = new Message("chan.control");

m->addParam("targetid","cpuload");

m->addParam("component","cpuload");

m->addParam("operation",monitor); // One of the following 

kernelLoad,userLoad,totalLoad,systemLoad

m->addParam("engine","interval_name,threshold_value,hysteresis_value;...... ");

Engine

:enqueue(m); // Engine::dispatch(m);

NOTE!

Target "engine" is reserved for engine call accept. If you want to modify engine monitors

or intervals please do it form manager.conf

[kernelLoad]

YATE CPU kernel-space load settings

[userLoad]

YATE CPU user-space load settings

[totalLoad]

YATE CPU load settings

[systemLoad]

System CPU load settings