User.auth
The user.auth is a message that requires from an authentication module a password for a certain user. If none of the authentication modules (regfile) know about this user then the module who started authentication will deny user registration in the system.
Channels like SIP, H.323, IAX and voicemail are sending a user.auth to the engine.
The main parameter for this message is username. Other parameters may be present depending on the protocol used.
Currently only SIP sends the parameters for digest authentication as follows:
- protocol=sip
- nonce=server supplied nonce
- realm=server supplied realm
- method=SIP method that is authenticated
- uri=SIP URI used in request
- response=Digest (MD5) response computed by client
There are also some parameters that may not be always available:
- ip_host=IP address from which the request was received
- ip_port=UDP or TCP port of the request
- address=ip_address:port of the request
Additional parameters may be set to filter which module handles this message. The default is to have all modules attempt to perform authentication:
- auth_register=false - Disables handling by the register database module
- auth_regfile=false - Disables handling by the regfile module
The returned value from the authentication module depends on the protocol:
- the plaintext password is returned and the sender must check it further;
- an empty string is returned if the user was authenticated by using supplied parameters;
- the message must be left unhandled to deny authentication
See also
