-
Sangoma Linux Driver (Wanpipe) require a list of packages on your system prior to install.
wanpipe-3.5.28.tgz
10 KB (1,440 words) - 16:11, 31 October 2013
-
* [[How to configure Yate as IAX server|Yate as IAX server and YateClient as IAX client]]
For basic setups configure yate to write single cdr entry per call, instead of entry for each call leg
9 KB (1,376 words) - 10:01, 27 October 2017
-
* Virtual Memory - Configure the system to allow plenty of virtual memory (ulimit -v) for Yate.
Expect to handle in the order of hundreds of call legs with Wanpipe drivers.
4 KB (758 words) - 16:06, 31 October 2013
-
Sangoma Wanpipe E1/T1 PRI cards signalling and data driver.
'''Note:'''The API for communicating with the wanpipe kernel drivers has changed over time.
9 KB (1,147 words) - 10:13, 4 November 2013
-
...Sangoma cards under Linux is somewhat similar with the installation of the Wanpipe driver under Linux, this being the necessary piece of software needed in or
wanpipe-[version].[item1].[item2].[item3].rpm
3 KB (430 words) - 16:12, 31 October 2013
-
This is a short example on how to configure MTP2 in Yate.
==Configure MTP2 in Yate==
975 B (160 words) - 08:57, 27 October 2017
-
sig=wanpipe1
... for it (unless when support was added in the hardware and then it's ok to configure filllink='yes').
7 KB (1,115 words) - 10:47, 27 October 2017
-
For an example of how to configure wanpipe and install sangoma drivers please check [http://docs.yate.ro/wiki/VoIP_PST
142 B (24 words) - 09:16, 26 October 2017
-
...mputer cards that have [http://sangoma.com/products/hardware_products.html wanpipe] or [http://www.asterisk.org/dahdi DAHDI] (former Zaptel) drivers.
...which order, but you can also use it to understand the objects you have to configure to make a specific setup.
3 KB (569 words) - 08:36, 27 October 2017
-
^123$=sig/1234567890;trunk=trunk2;circuits=wanpipe1<br>
^123$=sig/1234567890;trunk=trunk2;circuits=wanpipe1;calledpointcode=1-4-1<br>
36 KB (5,180 words) - 12:18, 26 October 2017
