Search results

Page title matches

• Configure M3UA
  M3UA is part of SS7 SIGTRAN protocol stack and it was designed for remote proces [[File:m3ua_routing.png]]
  11 KB (1,842 words) - 09:53, 27 October 2017

Page text matches

• How To's
  * [[How to configure Yate as IAX server|Yate as IAX server and YateClient as IAX client]] For basic setups configure yate to write single cdr entry per call, instead of entry for each call leg
  9 KB (1,376 words) - 10:01, 27 October 2017
• Telephony
  How to configure Yate to handle a SIP attended call transfer for an unknown call leg in the Configuration file used to configure H323 protocol in Yate
  8 KB (1,083 words) - 11:49, 27 October 2017
• Configure M3UA
  M3UA is part of SS7 SIGTRAN protocol stack and it was designed for remote proces [[File:m3ua_routing.png]]
  11 KB (1,842 words) - 09:53, 27 October 2017
• SCCP decoder
  ...sed as a SCCP message decoder. This case can be found if SCCP is used with M3UA-GW.<br/><br/> ...GT or/and SSN, in this way the SCCP is used to decode the SCCP message for M3UA-GW so that the gateway can look for the routing parameters.<br/>
  726 B (121 words) - 14:10, 26 October 2017
• M2PA VS M2UA
  ...document describes the differences between [[Configuring M2PA|M2PA]] and [[Configure M2UA|M2UA]]. * [[Configure M3UA]]
  4 KB (697 words) - 09:54, 26 October 2017
• SCCP Introduction
  It runs over a SS7 layer 3 protocol like MTP3 or M3UA. ...ATE instance is an "on demand" component. Basically this means that if you configure a SCCP section in ysigchan.conf but you do not reference it from a SCCP ap
  11 KB (1,757 words) - 09:19, 27 October 2017